Does NEC require tamper resistant outlets?
There are some primary locations where the NEC requires tamper-resistant outlets for all 15A, 20A, 125V, and 250V outlets: Residential dwellings: You are required to place tamper-resistant outlets in dwelling units like the kitchen, bathroom, laundry, garage, bedroom, living room, outdoors, etc.
When did NEC require tamper resistant outlets?
2008
Tamper-resistant (TR) receptacles were first required within the 2008 edition of the National Electrical Code (NEC).
Are tamper resistant GFCI outlets required?
As required by the 2008 national electrical code, tamper resistant GFCI’s should be installed in any new construction or renovation. Tamper resistant receptacles, commonly known as TRR, can help protect from electrical shock, injury, or even death.
How do you beat tamper resistant outlets?
If your tamper resistant outlet won’t open, there’s some consolation. These outlets loosen up with use. After installation, the best solution is simply to use the outlet a lot. Plug something in and unplug it about 100 times to loosen the outlet up.
Is tamper resistant outlet code?
406.12 Tamper-Resistant Receptacles.
Where are tamper resistant outlets required in homes?
Floor receptacles located more than 18 inches from the wall are required to be tamper-resistant, even though 210.52 does not specify these receptacles as required receptacles. In Section 210.52(A)(2)(1), a wall space is considered to be a wall that is at least 2 feet or more in width.
Should I install tamper resistant outlets?
Every home or apartment should have tamper-resistant outlets. Sooner or later, little kids will want to “see what happens if I stick a fork in there.” In fact, tamper-resistant outlets are important enough that modern codes require them in new homes and apartment buildings.
How do I know if my outlets are tamper resistant?
The letters “TR” are embossed between the two vertical slots (hot and neutral). Tamper resistant receptacles use a plastic shutter just inside the two vertical slots, and it will not release unless equal pressure is applied to both of them at the same time by the two prongs of an electrical cord.
Is tamper-resistant outlet code?
Where are tamper-resistant outlets required in homes?
Why won’t my plug go into the socket?
If you look in the slots there is usually a plastic piece blocking the opening on tamper resistant receptacles. I find wiggling the plug back forth with a light force will usually release the “doors” and allow the plug to go in.