Can you reset a Cobra radar detector?
Press and hold the “PROGRAM/MUTE” button for two (2) seconds. The detector will emit Three (3) beeps and PROGRAM will appear. Then brief programming instructions will scroll through the display three (3) times. Choose “RESTORE FACTORY SETTINGS”.
How do I update my Cobra iRAD?
Run (double click on Cobra update setup.exe) to install onto your PC and follow the InstallShield Wizard instructions. A desktop icon (Cobra Software Update) will be created on your desktop. 4. To update the firmware in the iRAD, connect the iRAD to your PC using a standard USB-A to USB-micro cable.
How do I connect my Cobra radar to the app?
In order to pair iRadar to your smartphone, go to the Bluetooth Settings Menu on your phone/tablet. For most devices this is found by pressing; Settings ▶ Bluetooth. Press Scan for Devices and/or wait for the Device list to populate and then select iRadar. Pairing can take up to 30 seconds.
How do you reset a cobra?
Step 1: Grab your AT Cobra. Step 2: Now, dial the code *2767*3855#. Step 3: After dialing the above code, you will see the option “Restore Factory Settings”. Step 4: Simply, choose the option in order to start the factory resetting process.
How do I setup my Cobra radar detector?
The factory settings are: X, K, and Ka Band On. While no signal is being detected, press and hold both the Dim and Mute buttons for four seconds. While no signal is being detected, press and hold both the Mute and City buttons for four seconds.
How do I reset my Cobra Road Scout?
To restore factory default settings: Hold the Power, SEN and BRT buttons while powering on the Road Scout. Press MARK button when prompted.
How do you set up a Cobra 480i radar detector?
Download the Cobra iRadar® App
- Power on RAD 480i – Make sure the unit is connected to your car’s 12V port.
- Install and run the Cobra iRadar app on your smartphone.
- In the iRadar app, press the Menu button then select “Devices”
- Select “RAD 480i” from the list.
How do you program a Cobra radar detector?
Press and hold the “PROG/MUTE” button for 2 seconds to enter Program mode. You will hear “start program” in Voice Alert mode or 3 beeps in Tone mode and “PROGRAM” will appear in the display. Brief programming instructions will scroll through the display two times. Choose “RESTORE FACTORY SETTINGS”.