What is jumper setting?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping.
What are the jumpers on a SATA drive for?
On SATA-II drives, a jumper is sometimes used to set the drive into SATA-I mode for compatibility with older controllers. Show activity on this post. Some SATA drives have jumpers to enable/disable 3Gb/s functionality or other backwards compatibility items.
How do you use a SATA hard drive jumper?
Four-Pin Seagate SATA Drives
- Locate the jumper block on the back of the Seagate SATA hard drive.
- Place the jumper over the first and second pin on the right to limit the drive’s data transfer to 1.5 Gigabits per second when it is being used in a server or multi-drive desktop with slow hard drives.
How do you switch jumpers?
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated. A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered.
How do you tell if a jumper is on or off?
When a jumper is considered “on,” it means that it’s covering at least two pins. A jumper that’s “off” is attached to only one pin. An “open jumper” is when none of the pins are covered with a jumper. You can usually just use your fingers to adjust a jumper, but needle-nose pliers are often a better alternative.
How do you use jumper pins?
Why is it important to set up the jumper first before installing the hard drive?
For IDE hard drives, it’s important to properly set the jumpers. If not properly done, your computer may not boot or the hard drive won’t be detected. If more than one device is on an IDE port, one device must be set to primary and the other set to secondary or cable select.
What is a SATA jumper?
A jumper pin is a rectangular connector that creates a circuit between two pins. Seagate SATA drives have four pins, while Western Digital SATA drives have eight pins, with the additional pins to be used by technicians or your network administrator for powering up the drive while in standby mode.
What are jumpers on a hard drive?
You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. They’re not used so much with modern hard drives, except in some special circumstances.
What is a jumper terminal?
Commonly refereed to as a “Jumper”, “Jumper Bar”, or “Terminal Block Jumper” It is a short length or conductor (commonly copper)that is used to connect two or more points in a electrical circuit. Very commonly used in industrial control panels. Are mainly intended for use with specific hardware, such as terminal blocks.
What is jumper in transmission line?
A jumper is a conductor that is rated to carry full line (load plus capacitive charging) current and is installed to connect line spans on opposite sides of a deadend or a large angle structure. The jumper is installed on each phase of the line and operates at full line voltage.
What are some of the settings that can be configured using jumpers?
Jumpers manually configure computer peripherals, such as the motherboard, hard drives, modems, sound cards, and other components. For example, if your motherboard supported intrusion detection, a jumper can be set to enable or disable this feature.