Where is the transmission control module located?
The transmission control module can often be found below the cover at the back of the transmission case. It should be just below the engine control module’s position. Sometimes it’s found under the center console in the interior or even under the hood near the battery or inner fender panel.
How much does a sprinter transmission cost?
The cost of a new Mercedes-Benz Sprinter Van transmission could be over $3,500 depending on the vehicle, however, transmission services such as fluid changes and a transmission fluid flush are considerably less expensive, in some cases costing less than $150.
How do I reset my TCM?
After turning on the car, you must shift through automatic transmission gear at least two times. In manual cars, shifting between drive and reverse should occur three times. The gear shifting must continue for at least 10 miles, automatically reset the transmission control module.
How many miles can a Mercedes Benz Sprinter last?
If you take good care of them with regular maintenance, Mercedes Sprinter vans can easily last for 300,000 miles or more. On the high end, it’s not unheard of for Sprinters to be going strong at 450,000+ miles. After 150,000 miles, it’s likely that you’ll be looking at your first major repairs.
How do you check transmission fluid on a Sprinter van?
How to Check Your Transmission Fluid – Automatic Transmissions
- Find the transmission dipstick, not to be confused with the oil dipstick.
- Take the dipstick out and inspect the fluid that is on the end.
- Wipe the dipstick clean and put it back in.
- Remove the dipstick again and check the fluid level.
What is considered high mileage for a Sprinter van?
How do you check the transmission fluid on a 2008 Mercedes Sprinter?
Checking your transmission fluid is quick and easy:
- Park your car on a level surface and turn on the engine. Let it warm up.
- Find the transmission fluid dipstick.
- Remove the dipstick and touch the fluid on the dipstick with your finger.
- Wipe off the dipstick with a rag, then reinsert it.
How does the wheel speed sensor work with the TCM?
The wheel speed sensor also works together with the TCM. Unlike having to manually engage the clutch with your left foot in a vehicle with a manual transmission, the wheel speed sensor tells the TCM when to decouple the transmission (aka engage the clutch).
Where is the fuse box on a Dodge Sprinter?
Fuse box in the driver’s seat The fuse box is located in the base of the driver’s seat on the outboard side. Dodge Sprinter – fuse box – in the driver’s seat Fuse block F55/3
How long does it take to replace a TCM module?
The cost of TCM replacement depends on the make and model of your vehicle, plus the cost of parts and labor. It’s also important to factor in the amount of time it could take to replace the module because some imported parts can take 2 to 4 weeks to arrive. TCM Swap & Labor