Why is my Dometic toilet not flushing?
There are two main reasons why your RV toilet is not flushing. First, water isn’t entering the bowl when the foot pedal is depressed, so waste is not washed away. Second, the water enters the bowl but does not exit. Both issues are symptomatic of larger problems and rectifying them can be time consuming and unpleasant.
What model is my Thetford toilet?
Using the data sticker to identify your Thetford toilet model. If you are not sure which model toilet you have, you will find a data sticker attached to the base of the toilet beneath the waste holding tank. The model number will be printed at the beginning above the barcode – as shown below.
How does a Dometic toilet work?
The pedal either fills the bowl with water or opens the valve into the holding tank, releasing all contents from the toilet into the tank for later dumping. Some toilets use a hand flush instead, but it works similarly in that it both fills and empties the bowl. A common problem is a broken seal.
How do you remove Thetford Aqua Magic RV toilet?
Disconnect the fresh water supply line and lift toilet straight up. For Aqua-Magic IV, disconnect the water supply line from the water valve located on the rear of the toilet. Remove the nuts from the closet flange bolts located on each side of the toilet. Carefully lift and remove the toilet from the closet flange.
Why is there no water coming to my RV toilet?
If your RV toilet won’t fill with water, it is typically because of an issue with the water valve. It could be as simple as the water valve being stuck. However, the water valve could need to be replaced. Try closing the valve, removing the hose, reattaching the hose, and turning on the water valve slowly.
Which RV toilet do I have?
The model number is inside under the toilet. Most common are model 300 (plastic) or 310(ceramic). It’s usually down near the floor, behind the bowl. If you have a phone with a camera, you might be able to get your arm back there and take a pic of it.
Which Dometic toilet do I have?
The model number is inside under the toilet. Most common are model 300 (plastic) or 310(ceramic). It’s usually down near the floor, behind the bowl.
How do you disassemble a Thetford toilet?
To gain access to the back bolt, lift up the seat and cover and remove the access hole, which should be located on top of the hopper. Then use a 12-inch extension with a universal and a 12-inch deep-well socket to remove the rear nut. Lift the Thetford toilet straight up off the closet flange.
What does a vacuum breaker do on a Thetford toilet?
The Thetford Replacement Vacuum Breaker is designed for Aqua Magic Style Plus, Style Lite and Style II permanent RV toilets. Fixes water leaks coming from the back of your toilet.